HEAT INDUCTION TREATMENT AND THE BALL DIAMETER LIMITATION IN POINT CONTACT SLEWING RINGS
Keywords:
slewing rings, CIF (high frequency induction hardening), C45 steel grade, 42CrMo4 steel grade, Hertzian contact, non-Hertzian contact analysis, compression Jominy curve, ball diameter limitationAbstract
The static and dynamic load capacity in slewing rings depends on the contact geometry and the surface and subsurface hardening parameter. Usually, for the large diameter slewing rings, the raceway treatment is the induction hardening. The specific depth varies between 1 mm to 8 mm, depending upon the hardening technique and the material composition and quality. In this paper, the surface and subsurface stresses will be examined taking into account the link between the ball
diameter and the material structure using a hardness compression algorithm. This reflects the contact limitations induced by the ball diameter and shows two possible regions for crack initiations in this rolling contact.
Downloads
Published
Issue
Section
License
All rights are reserved for this publication, which is copyright according to the Romanian law of copyright. Excepting only any fair dealing for the purpose of the private study, research, review, comment and criticism, no part of this publication may be reproduced, stored in a retrieval system or transmitted in any form or by any means, mechanical, electrical, electronic, optical, photocopying, recording or otherwise, without the prior express permission of the copyright owners.
