Vol. 23 (2005)

Articles

• Mise en évidence de l’influence de la loi de comportement sur la génération de la surface d’un copeau lors de la simulation numérique de la coupe orthogonale

  Pascal Caestecker, Adinel Gavrus, Eric Ragneau

  5-10

  • PDF

• Study on the transient conjugated heat transfer in developing laminar pipe flow

  Maria Neagu, Maricica Dodu

  11-14

  • PDF

• The modeling of the generation of conical polyform surfaces

  Nicolae Oancea, Marius Mihăluță, Virgil Teodor, G. Pîrvu

  15-22

  • PDF

• Software for blank’s minimum rolling radius determination

  Francisco Javier Santos Martin, Virgil Teodor

  23-25

  • PDF

• Algorithm for hypoid gear study

  Nicolae Oancea, Clara Panait, Virgil Teodor

  26-31

  • PDF

• Particularities on hydrostatic extrusion technological variants

  Ovidiu Dumitru Ciocan

  32-35

  • PDF

• Elements specifically to pressurization (sealing/ tightening) in hydrostatic extrusion processes

  Ovidiu Dumitru Ciocan, Dumitru Nicoară

  36-38

  • PDF

• Active control of convection in a melted material layer I. Convection in an infinite fluid layer

  Maria Neagu

  39-43

  • PDF

• Active control of convection in a melted material layer II. Convection with a finite lower boundary

  Maria Neagu

  44-47

  • PDF

• Equipment for the study of tribological aspects of hip prostheses

  Cătălin Fetecău, Cosmin Giurgea

  48-54

  • PDF

• Experimental researches regarding the forming limit curves using reduced scale samples

  Viorel Păunoiu, Dumitru Nicoară, Ana Maria Cantera Lopez, Pedro Arroyo Higuera

  55-59

  • PDF

• Numerical simulation of forming limit curves using reduced scale samples

  Viorel Păunoiu, Dumitru Nicoară, Ana Maria Cantera Lopez, Pedro Arroyo Higuera

  60-65

  • PDF

• The establishment of compatibility domain in the case of kinematics groups with two common wheels

  Ștefan Mitu, Gabriel Frumușanu, Constantin Stoian

  66-69

  • PDF

• The theory of unary gears

  Eugen Ghiță

  70-73

  • PDF

• The influence of the geometry of the lathe tool on the surface condition at the processing of the polyamide PA 66 – GF 30

  Marin Moțoi-Cristescu

  74-79

  • PDF

• Analytical model of worm hob errors with continuous sharpening

  Nicu Căpătînă

  80-84

  • PDF