S-FMECA Based Collaborative Design Proposal for Additive Manufacturing Methodology

Authors

  • N. Chtioui Laboratory of Mechanical Engineering (LGM), National Engineering School of Monastir (ENIM), University of Monastir, Rue Ibn El Jazzar, 5000 Monastir, Tunisia and Higher Institute of Technological Studies of Sousse, Cité Erriadh, 4000 Sousse, Tunisia
  • R. Gaha Roberval Mechanics Laboratory UMR-CNRS 7337, Royallieu Research Center, University of Technology of Compiègne, France
  • S. Chatti Laboratory of Mechanical Engineering (LGM), National Engineering School of Monastir (ENIM), University of Monastir, Rue Ibn El Jazzar, 5000 Monastir, Tunisia
  • A. Benamara Laboratory of Mechanical Engineering (LGM), National Engineering School of Monastir (ENIM), University of Monastir, Rue Ibn El Jazzar, 5000 Monastir, Tunisia

DOI:

https://doi.org/10.35219/awet.2023.04

Keywords:

eco-design methodology, S-FMECA, topology optimization, collaborative design, sustainability

Abstract

In the current context, the sustainable development, eco-design and eco-manufacturing concepts are being developed in research laboratories, and further being integrated gradually into manufacturing industries. Hence, the needed information for eco-design is scattered throughout the product life cycle and is not centralized; especially when designing for Additive Manufacturing. This paper aims to develop a collaborative eco-design methodology by using eco-design tools in different design stages and, finally, to contribute to tackling this issue. Either in the early design stage or in the detailed on, the designer will be supported to make sustainable, conscious decisions. The proposed methodology based on the sustainable-failure modes, effects, and criticality analysis (S-FMECA) eco-designing tool allows the communication with computer-aided design (CAD), computer-aided manufacturing (CAM), life cycle assessment (LCA), topology optimization (TO) and product life cycle management (PLM) software in order to assist the designer to make green-conscious decisions.

Downloads

Download data is not yet available.

Downloads

Published

2023-12-28

Issue

Vol. 34 (2023)

Section

Articles

License

Papers accepted for publication become the copyrighted property of the Annals of "Dunarea de Jos" University of Galati, Fascicle XII, Welding Equipment and Technology. No part of the publication may be reproduced or transmitted in any form, or by any means, electronic or mechanical, including photocopy, recording, or any information storage and retrieval system, except in limited quantities for the non-commercial purposes of scientific or educational advancement, without permission in writing from the Editorial Board.

How to Cite

S-FMECA Based Collaborative Design Proposal for Additive Manufacturing Methodology. (2023). Annals of “Dunarea de Jos” University of Galati. Fascicle XII, Welding Equipment and Technology, 34(1), 36-48. https://doi.org/10.35219/awet.2023.04

Most read articles by the same author(s)

<< < 1 2