Selection of the most Suitable CZM Conditions in the Finite Element Strength Prediction of Adhesive Joints
Keywords:
Bonded joints, Finite Element Method, Adhesives, Cohesive zone models, Strength predictionAbstract
The adhesively-bonding technique is widely used in the industry to join components. Strength prediction of these joints with Cohesive Zone Models (CZM) coupled to Finite Element (FE) analyses is one of the most widespread methods, which allows simulation of crack propagation in the adhesive layer. The present study addresses this issue, and more specifically the influence of the damage law shape used to simulate the adhesive layer behaviour in the FE model of single-lap adhesive joints. This procedure enabled an estimation of the damage law influence on the strength prediction under different material conditions. It was showed that the predicted strength of joints with ductile adhesives is highly dependent on the CZM shape, and that the trapezoidal CZM is the best approximation. Conversely, brittle adhesives are accurately modelled disregarding the damage law shape.
Downloads
Downloads
Published
Issue
Section
License
Papers accepted for publication become the copyrighted property of the Annals of "Dunarea de Jos" University of Galati, Fascicle XII, Welding Equipment and Technology. No part of the publication may be reproduced or transmitted in any form, or by any means, electronic or mechanical, including photocopy, recording, or any information storage and retrieval system, except in limited quantities for the non-commercial purposes of scientific or educational advancement, without permission in writing from the Editorial Board.
